top of page
MG_7358.jpg

HOW TO CHOOSE THE SIZE

OF the helmet

Misure casco

A helmet that is not worn correctly could reduce protection. 

Follow the instructions to understand how to best choose the size of the helmet.

Get help from a coach or a relative so that there are no mistakes.

​

MEASURE YOUR HEAD:

use a tape measure to measure the circumference of the head

CHOOSE THE SIZE:

Following the table below, choose the size that best suits you:

tabella_taglie_casco.jpg

EYEBROWS:

The helmet padding should be just above the lifter's eyebrows with the top bar of the goggle about an inch above them

 

NOSE:

The athlete's nose should be at least two inches away from the mask

 

head:

The helmet should cover the entire back of the head. Including the occipital bone (posterior base of the skull)

​

ears:

The ears should be visible within each hole of the ear canals.

​

Many football helmets use portable pumps to fill bladders in order to achieve a proper fit.

Xenith, on the other hand, uses an adaptive system to provide superior performance and comfort to the athlete, guaranteeing a personalized fit without the discomfort of inner tubes.

When you engage the integrated Xenith chinbar, the internal shock absorbing matrix conforms to your head for a uniform 360° fit with zero pressure points for maximum comfort and protection.

THE FIRST TIME YOU WEAR IT

A XENITH HELMET

adaptive_fit_arrows_1200x670_160ae411-4c

There are 5 easy steps to fit a Xenith helmet.

​

WEAR YOUR HELMET:

Loosen the straps and pull the Xenith chinbar towards the facemask to free up space to position the helmet on your head so that the front edge is just above the forehead. Then pull the lower chin straps outward until the chin bar slides up to meet your chin. The internal suspension system will tighten until it is snug and secure around your head.

 

Adjust the straps and fix the clips:

Slide each strap along the chin strap until you can snap the clip into place on the outside of the helmet without any discomfort or slack in the straps.

​

check that it fits correctly

With all four clips snapped into place, apply gentle force to the facemask in multiple directions. If there is excessive movement, tighten the chin strap straps and re-adjust  until you get a snug and secure fit.

​

TAKE OFF THE HELMET

To remove the helmet, undo the straps and pull the chin guard towards the goggle to free up space so that the helmet can be easily removed.

XENITH HELMET SIZES

shadow_xr_size.png
bottom of page